12
Using Manual Tuning
SETTINGS SETUP Manual Tuning
Adjusts programmes manually and saves the results.
For digital broadcasting, signal strength and signal quality can be
checked.
For analogue broadcasting, you can set up station names and use
ne tuning (except for Satellite mode). Normally ne tuning is only
necessary if reception is poor.
Editing programmes
SETTINGS SETUP Programme Edit
Edits the saved programmes.
Set as favourite programme, block/unblock programme, skip
programme etc. of the selected programme.
To select Programme mode
SETTINGS SETUP Programme mode
This function allows you to watch a tuned programme in Antenna,
Cable, Satellite Mode.
• You can only watch programmes in the selected mode.
About CI Information
SETTINGS SETUP CI Information
[This feature is available on certain models only.]
• This function enables you to watch some encrypted services (pay
services).
• If you remove the CI Module, you cannot watch pay services.
• CI (Common Interface) functions may not be possible depending
upon the country broadcasting circumstances.
• When the module is inserted into the CI slot, you can access the
module menu.
• To purchase a module and smart card, contact your dealer.
• When the TV is turned on after inserting a CI Module, you may not
have any video and audio output in scrambled programme. The
Smart Card may not be compatible with the CI module.
• When using a CAM(Conditional Access Module), please make sure
it meets fully the requirements of either DVB-CI or CI plus.
• An abnormal process of CAM(Conditional Access Module) may
cause a bad picture.
• [This feature is available on certain models only.] If the TV does not
display any video and audio when CI+ CAM is connected, please
contact to the Terrestrial / Cable / Satellite Service Operator.
To set current time
SETTINGS TIME Clock
Checks or changes the time while watching TV.
• Auto : Synchronizes the TV clock to the digital time information
sent by the TV station.
• Manual : Sets the time and date manually if the auto setup does
not correspond to the current time.
To set the TV to turn on and o automatically
SETTINGS TIME Off Time / On Time
You can set the Power On/O time for the TV.
Select Off if you are not going to set Off Time / On Time.
• To use Off Time / On Time, set the current time correctly.
• Even when the On Time function is on, the TV will turn o
automatically in 120 minutes when no button is pressed within
that time.
To use Sleep Timer
SETTINGS TIME Sleep Timer
Turns o the TV after a preset number of minutes.
To cancel the Sleep Timer, select Off.
To set Automatic Standby
SETTINGS TIME Automatic Standby
[This function is available on certain models or in certain countries only]
If you do not press any button on the TV or remote control for a certain
period, the TV will automatically switch to standby mode.
• This function does not work on Store mode or while software
update.
To set password
SETTINGS LOCK Set Password
Sets or changes the TV password.
• The initial password is set to ‘0000’.
• When France is selected for Country, password is not ‘0000’ but
‘1234’.
• When France is selected for Country, password cannot be set to
‘0000’.
To Next Page
Loading...
