LG 43UR8050PSB - Page 21

- 21 -
Copyright © LG Electronics Inc. All rights reserved.
Only for training and service purposes.
[LED Array Disassemble]
(1) Disassemle the CNT form LED Array.
(2) Separate the LED Array from Cover Bottom.
(3) Remove the double tape form Cover Bottom.
* After removing LED array once, You should not use it again.
[LED Array Assemble]
(Step 1) Attach the Double Tape
1) Attach the double tape to the round hole on Cover Bottom embo.
2) Remove the protect film of Double Tape with taking off the handler.
(Step 2) Attach the LED Array
1) Attach the LED Array to the round hole on Cover Bottom embo.
2) Press the LED Array on the surface of Cover Bottom.
3) Connect the CNT to the LED Array.
* Finish the Attached LED Array (5ea)
double tape
Pull to the
upside
Connector(CNT)
handler
NG
OK
Round hole