Voltage and speaker checking method
when there is no audio
C. Audio error_No audio/Normal video
A21
Error
symptom
Content
A21
Standard Repair Process Detail Technical Manual
Established
date
Checking order when there is no audio
1. Check the contact condition of or 13.2V connector of Main Board.
2. Measure the 13.2V input voltage supplied from Power Board.
(If there is no input voltage, remove and check the connector.)
3. Connect the tester RX1 to the speaker terminal and if you hear the Chik Chik
sound when you touch the GND and output terminal, the speaker is normal.
①
③
1 SPK_R-FT
2 SPK_R+FT
3 SPK_L-FT
4 SPK_L+FT
②
SET Model
Power P/N, Name
To Next Page
Loading...
