LG 47CM565 - Page 3

Network Quick Setup Guide
ENGLISH
Troubleshooting Network Problems
1

Press the SETTINGS button to access the main menu.
2

Select the NETWORK
→
Network Status menu.
Follow the instructions below that correlate to your network status.
Check the TV or the router.
When an X appears between TV and Gateway.
1
Check the cable connection between the TV and the wired router.
2
Reset the power for both the TV and the router/cable modem.
3
If you use a fixed IP address and choose to set the IP address automatically, an X will appear
between TV and Gateway.
4
If you are not using a router, consult your Internet service provider for service.
Check the router or consult your Internet service provider.
When an X appears between Gateway and DNS.
1
Check the router/cable modem.
- Unplug the router/cable modem, then plug it back in after 5 seconds.
- Press the Reset button on the router/cable modem.
2
If you are not using a router, consult your Internet service provider.
When an X appears between DNS and Internet.
1
Unplug the router/cable modem, then plug it back in after 5 seconds.
2
Press the Reset button on the router/cable modem.
3
Check that the MAC address of the TV/router is registered with your Internet service
provider. (The MAC address displayed on the right pane of the network status window should
be registered with your Internet service provider.)
4
Check the router manufacturer’s website to make sure your router has the latest firmware
version installed.
Read the Owner's Manual to find out the system requirements.
a
b
1
Start Nero Media Home 4 and enable shared folders on your
PC.
»
»
a
. Click the Share button.
»
»
b
. Click the Add button and select the desired folder.
(Read the Owner's Manual to find out which file formats
support the DLNA function.)
c
d
2
Make sure that the PC network device is selected.
»
»
c
. Click the Network button and check that the correct PC
network device is selected. (At least one network device
must be selected.)
»
»
d
. Click the Start Server button.

PICTURE AUDIO CHANNEL TIME
LOCK OPTION NETWORK MY MEDIA
Press OK(ꔉ) to set your option settings.
Customer Support Exit
e
Please select the device.
Page 1/1
USB DISK
DLNA Device
ꔉ Device Selection
Close
f
3
You can view and enjoy shared content by using the TV’s My
Media function.
DLNA Device
»
»
e
. Select DLNA Device on the TV’s My Media to enjoy
content from your PC.
Install the SmartShare PC SW (DLNA) program on your PC.
1

Go to www.lg.com. Then, select your region.
2

Select Support. Then, Search for your model.
3

Select Drivers & Software. Then, select SmartShare PC SW (DLNA).
4

You can run the program when installation is complete.
y
DLNA service is available if TV and other devices are connected via a single router.
NOTE
SmartShare PC SW Installing & Setting
DLNA Connection to PC