\6
ENGLISH
¡xy u wy } w{{vw }z{
(Depending on model)
Transmits the video and audio signals from an external device to the
TV set. Connect the external device and the TV set with the euro scart
cable.
¢£¤¥£¤
Type
Current
input mode
AV1
(TV Out
1
)
Digital TV Digital TV
Analogue TV, AV
Analogue TVComponent
HDMI
1 TV Out : Outputs Analogue TV or Digital TV signals.
tAny Euro scart cable used must be signal shielded.
tWhen watching digital TV in 3D imaging mode, only 2D out signals
can be output through the SCART cable. (Only 3D models)
Other connections
Connect your TV to external devices. For the best picture and audio
quality, connect the external device and the TV with the HDMI cable.
Some separate cable is not provided.
Remote control
(Depending on model)
The descriptions in this manual are based on the buttons on the remote
control. Please read this manual carefully and use the TV correctly.
To replace batteries, open the battery cover, replace batteries (1.5
V AAA) matching the
and ends to the label inside the
compartment, and close the battery cover. To remove the batteries,
perform the installation actions in reverse.
:;< =
tDo not mix old and new batteries, as this may damage the remote
control.
tThe remote control will not be included for all sales market.
Make sure to point the remote control toward the remote control sensor
on the TV.
A
B
1 2
3
¦
(POWER)
%
(
G
)
C
( F
!
-
D $
)
F
alls your preferred subtitle in digital mode.
1
B*
((
!$
,
D
&%
-
%
!
(
!!
(
"
%
! #!
be enabled. (Depending on model)
1
C
ws programme guide. (Depending on model)
2
F
(
!
7
es an image. (Depending on model)
2
C
(
,
)
4D!$ J
Changes the input source.
Number buttons
E
(
%
&
()
,
((
(
(
0
$ !
(
)
F
%
(
o the previously viewed programme.
B
,
((
( *
%
"
0
%
! $ !
(
)
3
C
ws programme guide. (Depending on model)
3
U
(
"
0
!#!$
D
0
!
)
4D!$ J
M
%
es all sounds.
,
/
%(
(
0
%
0
)
C
(
%
$
(
0
$
()
Moves to the previous or next screen.
To Next Page
Loading...
