LG 49UF7787 - Preparing the TV for Use; Initial Setup, Connections, and Notes

ENGLISH
11
Preparing
NOTE
• If the TV is turned on for the rst time
after it was shipped from the factory,
initialization of the TV may take a few
minutes.
• Image shown may dier from your TV.
• Your TV’s OSD (On Screen Display) may dier
slightly from that shown in this manual.
• The available menus and options may dier
from the input source or product model that
you are using.
• New features may be added to this TV in the
future.
• The TV can be placed in standby mode in
order to reduce the power consumption.
And the TV should be turned o if it will
not be watched for some time, as this will
reduce energy consumption.
• The energy consumed during use can
be signicantly reduced if the level of
brightness of the picture is reduced, and
this will reduce the overall running cost.
• The items supplied with your product may
vary depending on the model.
• Product specications or contents of this
manual may be changed without prior
notice due to upgrade of product functions.
• For an optimal connection, HDMI cables
and USB devices should have bezels less
than 10 mm thick and 18 mm width. Use an
extension cable that supports USB 2.0 if the
USB cable or USB memory stick does not t
into your TV’s USB port.
A
B
A
B
*A
<
=
10 mm
*B
<
=
18 mm
• Use a certied cable with the HDMI logo
attached.
• If you do not use a certied HDMI cable, the
screen may not display or a connection error
may occur. (Recommended HDMI Cable
Types)
- High-Speed HDMI®/
TM
Cable (3 m or less)
- High-Speed HDMI®/
TM
Cable with Ethernet
(3 m or less)
CAUTION
• Do not use any unapproved items to ensure
the safety and product life span.
• Any damage or injuries caused by using
unapproved items are not covered by the
warranty.
• Some models have a thin lm attached on
to the screen and this must not be removed.
• Do not remove the panel with your ngers
or any tools. Doing so may damage the
product. (Only UF95**)
• When attaching the stand to the TV
set, place the screen facing down on a
cushioned table or at surface to protect
the screen from scratches.
• Make sure that the screws are inserted
correctly and fastened securely. (If they are
not fastened securely enough, the TV may
tilt forward after being installed.) Do not
use too much force and over tighten the
screws; otherwise screw may be damaged
and not tighten correctly.