I
6
IMPORTANT
SAFEt:Y INSTRUCTIONS
••
If the
TV
feels cold
to
the touch, there may
be
a small "flicker"
when
it
is
turned
on.
This
is
normal, there
is
nothing wrong with
TV.
Some minute
dot
defects may be visible
on
the screen, appearing
as
tiny red, green, or
blue spots. However, they have
no
adverse
effect
on
the TV's performance. Avoid
touching the
LCD
screen or holding your
finger(s) against it for long periods of time.
Doing so may produce some temporary
distortion effects
on
the screen.
The fluorescent lamp used
in
this product contains
a small amount of mercury.
Do
not dispose of
this product
with
general household waste.
Disposal of this product must be carried out
in
accordance to the regulations of your local
authority.
• If a fixed image displays
on
the
TV
screen for
a long period of time, it will be imprinted
and
become a permanent disfigurement
on
the
screen. This
is
"image burn" or "burn-in"
and
not covered by the warranty.
• If the aspect ratio of the
TV
is set to 4:3 for a
long period of time, image burn may occur
on
the letterboxed
area
of the screen.
• Avoid displaying a fixed image
on
the
TV
screen
for a long period of time
(2
or more hours for
LCD,
1 or more hours for the Plasma
TV)
to
prevent image burn.
For
USA
and
canada
This equipment
has
been tested and found
to comply with the limits for a Class B
digital device, pursuant to
Part
15 of the
FCC
Rules. These limits
are
designed to
provide reasonable protection against harmful
interference
in
a residential installation.
This equipment generates, uses and
can
radiate radio frequency energy and, if not
installed and used
in
accordance
with
the
instructions, may cause harmful interference
to
radio communications. However, there
is
no guarantee that interference will not occur
in
a particular installation. If this equipment
does cause harmful interference
to
radio or
television reception, which
can
be determined
by turning the equipment off and on, the user
is
encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment
and
the receiver.
- Connect the equipment to
an
outlet
on
a circuit different from that
to
which the
receiver
is
connected.
- Consult the dealer or
an
experienced radiol
TV
technician for help.
This device complies with part 15 of the
FCC
Rules. Operation
is
subject to the following
two
conditions:
(1)
this device may not cause
harmful interference
and
(2)
this device
must
accept any interference received, including
interference that may cause undesired
operation of the device.
Any changes
or
modifications
in
construction of
this device which
are
not expressly approved
by the party responsible for compliance
could void the user's authority
to
operate the
equipment.
This reminder
is
provided to call the
CATV
system installer's attention to Article 820-40 of
the National Electric Code (U.S.A.). The code
provides guidelines for proper grounding and,
in
particular, specifies that the cable ground
shall be connected to the grounding system of
the building,
as
close to the point of the cable
entry
as
practical.
To Next Page
Loading...
