LG 55LM7600 - Mounting on a Table

17
ENG
ENGLISH
ASSEMBLING AND PREPARING
Mounting on a table
1
Lift and tilt the TV into its upright position on a
table.
- Leave a 10 cm (4 inches) (minimum) space
from the wall for proper ventilation.
10 cm
10 cm
10 cm
10 cm
(4 inches)
2
Connect the power cord to a wall outlet.
CAUTION

Do not place the TV near or on sources
of heat, as this may result in fire or other
damage.
Securing the TV to a table
(Depending on model)
Fix the TV to a table to prevent from tilting
forward, damage, and potential injury.
1
Connect the Desk-mount Cables to the Stand
Base using the Bracket Screws.
2
Fix the Desk-mount Cables to a table using the
Desk-mount Screws.
3
Once the TV is fixed, move the table close to
the wall. Children may go in, causing injuries.

M4 x 8
2 EA
WARNING

To prevent TV from falling over, the TV
should be securely attached to the floor/wall
per installation instructions. Tipping, shaking,
or rocking the TV may cause injury.
Adjusting the angle of the TV to suit view
Swivel 10±2 degrees to the left or right and adjust
the angle of the TV to suit your view.
10 210 2
NOTE

When adjusting the angle of the TV, watch
out for your fingers.

»
Personal injury may occur if hands or fingers are
pinched. If the product is tilted too much, it may fall,
causing damage or injury.
MFL67468132_00.indb 17 2012-02-07 �� 1:40:29