4 | INTRODUCTION
Single Zone Art Cool Gallery Owner’s Manual
Due to our policy of continuous product innovation, some specications may change without notication.
Single Zone Art Cool Gallery
SAFETY INSTRUCTIONS
•Please read this manual completely before operation of the product.
•Follow the instructions in this manual to prevent product malfunction, property damage, injury or death to the user or other people.
Incorrect operation due to ignoring any instructions will cause harm or damage.
•The level of seriousness is classified by the symbols described below.
IMPORTANT!
This symbol indicates a potentially hazardous situation which, if not avoided, may result in death or serious injury.
This symbol indicates a tip or recommendation.
Recommendations instruct the user to apply the suggested practice to ensure the best operating results in order to achieve the
maximum benet of the product.
Tips contain practical information that may help the user solve a problem or describe actions that may save time.
This symbol indicates additional helpful information such as an explanation, a comment, or a clarication about the subject.
General Safety
• Installation and repair must always be done by a qualied technician.
• Installation MUST conform with local building codes or, in the absence
of local codes, with the Nation Electrical Code NFPA 70/ANSI C1-1003
or current edition and Canadian Electrical Code Part1 CSA C.22.1.
Power and Electrical Safety
• Immediately disconnect the product in the event of a blackout or
thunderstorm. Failure to do so may result in fire, electric shock and/
or damage.
• Always insure proper equipment ground. Failure to do so may result
in electric shock and/or product failure.
• Be sure a circuit breaker is installed before using the air conditioner.
Failure to do so may result in electric shock and/or product failure.
• Do not connect the ground wire to a gas pipe, a lightning rod or a
telephone ground wire; because it may result in electric shock and/
or product failure.
• Use a standard circuit breaker and fuse conforming to the rating of
the air conditioner. Failure to do so may result in electric shock and/
or product failure.
• Do not modify or extend the power cable; because it may result in
electric shock and/or fire. If the power cable shows wear, such as
scratches or outer skin peeling off or deteriorated, then it must be
replaced.
• Do not use a damaged power cord; because it may result in electric
shock and/or fire.
• Do not touch, operate or repair the air conditioner with wet hands.;
because it may result in electric shock or product failure.
• Do not place a heater or other heat generating appliances near the
power cable; because it may result in electric shock and/or fire.
• Check that the power cord is not pulled or damaged while the air
conditioner is operating. Failure to do so may result in electric shock,
electric shock and/or fire.
• Do not place any objects on the power cord; because it may result in
electric shock or product failure.
• Failure to carefully read and follow all instructions in this manual
may result in equipment malfunction, property damage, personal in-
jury and/or death.
To Next Page
Loading...
