Why LG AUUW368D2 does not cool or heat effectively?
Ineffective cooling or heating could be due to an incorrect temperature setting. Also, check if the air inlet or outlet vents of the indoor unit are obstructed.
What to do if filter sign lamp (LED) is ON on my LG Air Conditioner?
If the filter sign lamp (LED) is on, clean the filter. After cleaning, press the Timer button and the '?' button on the wired remote controller simultaneously for 3 seconds.
What to do if my LG Air Conditioner does not operate?
First, check if you've made any mistakes in setting the timer. Also, verify whether a fuse has blown or if the circuit breaker has been tripped.
What to do if error code occurred on LG AUUW368D2 after lightning struck?
The error code appeared because the over current protection circuit has been activated. This is normal behavior, and the unit should operate normally after a few minutes.
Why LG AUUW368D2 does not operate for about 3 minutes when restart?
The air conditioner's delay in restarting is due to a built-in mechanism protector. Please wait approximately three minutes, and the operation will begin automatically.
Highlights critical safety warnings and professional service recommendations.
Covers grounding, circuit breakers, wiring, and power cords for electrical safety.
Addresses installation stands, cable modifications, outdoor unit placement, and product handling.
Guides on operating the unit for cooling and rapid cooling modes.
Instructions for operating in heating and dehumidifying modes.
How to set airflow direction, speed, and room temperature.
Procedures for cleaning the indoor unit and its primary air filters.
Common issue diagnosis and when to contact service personnel immediately.
General| Brand | LG |
|---|---|
| Model | AUUW368D2 |
| Category | Air Conditioner |
| Language | English |
To Next Page
