101101
harmful interference.
(2) This device must accept any
interference received, including
interference that may cause
undesired operation.
Part 15.21 statement
Changes or modifications that are
not expressly approved by the
manufacturer could void the user’s
authority to operate the
equipment.
Part 15.105 statement
This equipment has been tested
and found to comply with the limits
for a class B digital device, pursuant
to Part 15 of the FCC rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular
installation. If you experience
interference with reception (e.g.,
television), determine if this
equipment is causing the harmful
interference by turning the
equipment off and then back on to
see if the interference is affected. If
necessary, try correcting the
interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between
the equipment and receiver.
- Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
- Consult the dealer or an
experienced radio/TV technician
for help.
VN251S_VZW_UG_EN_V1.0_130410.qxd 4/11/13 1:44 PM Page 101
To Next Page
Loading...
Need help?
General
