LG CQ09 NA0 - High Ceiling Operation

- 40 -
Copyright ©2013 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Part 2 Functions & Controls
4.2 High Ceiling operation
Function Code Thermistor setting
Select ceiling height value by pressing button. (01:Low,
02:Medium, 03:High, 04:Very high)
3
Press button to save.
4
5
If moving to ceiling height selection menu by pressing button,
it indicates as picture below.
2
If pressing button long for 3 seconds, it enters into
remote controller setter setup mode.
- If pressing once shortly, it enters into user setup mode.
Please press more than 3 seconds for sure.
1
Pressing button will exit settings mode.
❈ After setup, it automatically gets out of setup mode if there is no button input
for 25 seconds.
❈ When exiting without pressing set button, the manipulated value is not
reflected.
This function is to adjust FAN Airflow rate according to ceiling height (For ceiling type product)
• Ceiling height setting is available only for some products.
• Ceiling height of ʻVery highʼ function may not exist depending on the indoor unit.
• Refer to the product manual for more details.
<Ceiling Height Selection Table>
Ceiling Height Level Description
01 Low Decrease the indoor airflow rate 1 step from standard level
02 Medium Set the indoor airflow rate as standard level
03 High Increase indoor airflow rate 1 step from standard level
04 Very high Increase indoor airflow rate 2 steps from standard level