49
ENGLISH
TROUBLESHOOTING
Before Calling For Service (cont.)
Steam does not
generate but
no error code is
shown
Garments still
wrinkled after
STEAM FRESH™
of garments in dryer.
There are no
creases left on
garment after
STEAM FRESH™
remove wrinkles from fabric.
Garments have
static after
REDUCE STATIC
Garments are
too damp or
too dry after
REDUCE STATIC
selected.
STATIC option.
Garments are
not uniformly
damp after
EASY IRON
Number of garments or load
size not properly selected at the
beginning of the cycle.
starting the cycle.
Water drips
from door
during Steam
Cycle
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
Steam is not
visible during
Steam Cycle
However, condensation will normally form on the inside of
the dryer door if the steam system is operating normally.
Drum does not
turn during
Steam Cycle
the drum. The drum will normally turn for about 2 seconds
once a minute.
Cannot see
steam vapor at
the beginning
of cycle
option.
MFL67731047_en_160822.indd 49 2016.8.22 9:48:50 AM
To Next Page
Loading...
