Tools Needed for Installation:
Phillips screwdriver
WARNING
To reduce the risk of electrical shock, fire, explosion, property damage, serious injury, or death, follow basic
precautions, including the following:
The weight of the dryer and the height of installation make this stacking procedure too risky for one person. Two
or more people are
required when installing the stacking kit.
Do not use the stacking kit with a gas dryer in potentially unstable conditions such as a mobile home.
Place the washer on a solid, stable, level floor capable of supporting the weight of both appliances.
Do not stack the washer on top of the dryer.
If appliances are already installed, disconnect them from all power, water, or gas lines and from draining or
venting connections.
To ensure safe and secure installation, please observe the following instructions.
1. Make sure the surface of the washer is clean and dry. Remove paper backing from the tape on one of the
stacking kit side brackets.
2. Fit the side bracket to the side of the washer top as shown in the below illustration. Firmly press the adhesive
area of the bracket to the washer surface. Secure the side bracket to the washer with a screw on the backside
of the bracket.
Repeat steps 1 and 2 to attach the other side bracket.
3. Place the dryer on top of the washer, fitting the dryer feet into the side brackets as illustrated. Avoid finger
injuries; do not allow fingers to be pinched between the washer and dryer.
Slowly slide the dryer toward the back of the washer until the side bracket stoppers catch the dryer feet.
To Next Page
Loading...
Need help?
General
