To Next PageTo Next Page
Need help?Do you have a question about the LG DLE3777W and is the answer not in the manual?
General| Type | Electric |
|---|---|
| Capacity | 7.4 cu. ft. |
| Color | White |
| Steam Refresh | No |
| Steam Sanitary | No |
| Allergiene Cycle | No |
| Drying Rack | Yes |
| Reversible Door | Yes |
| SmartDiagnosis | Yes |
| ENERGY STAR Qualified | Yes |
| Temperature Settings | High, Medium High, Medium, Low, Ultra Low |
| Features | Sensor Dry, Wrinkle Care |
| Drying Programs | Multiple |
Title page of the service manual for LG electric and gas dryers.
General warnings about power disconnection and grounding for safe servicing.
Steps to follow in case of detecting a gas leak.
Guidelines for preventing damage from electrostatic discharge to electronic components.
Detailed specifications for LG dryers, including dimensions and capacity.
Information on optional dryer accessories like racks and pedestals.
Highlights of the dryer's key features and user benefits.
Instructions for installing the dryer rack inside the drum.
Step-by-step guide for securely stacking the dryer on a washer.
Instructions for mounting the dryer onto an optional pedestal.
Guidance for 4-wire power supply and direct wiring configurations.
Guidance for 3-wire power supply and direct wiring configurations.
Detailed steps for a 3-wire direct electrical connection.
Instructions for connecting a 4-wire power supply cord.
Instructions for connecting a 3-wire power supply cord.
Steps for an optional 3-wire connection configuration.
Procedure for connecting the gas supply pipe to the gas dryer.
Details on Sensor Dry cycle types, settings, and operation.
Details on Manual Dry cycle types, settings, and operation.
Testing procedures for thermal cut-offs and thermostats.
Procedures for testing door and idler switches.
Testing resistance values for heater, thermistor, and motor components.
Testing procedures for gas valve, igniter, and flame detector.
Testing procedures for auto and manual reset outlet thermostats.
Diagram and explanation of the centrifugal switch in stop and run modes.
Diagram showing the layout of the PWB assembly display.
Diagram showing the detailed layout of the PWB assembly.
Wiring schematic for the electric dryer model.
Wiring schematic for the gas dryer model.
Steps to activate the diagnostic test mode for troubleshooting.
Table detailing actions, display readings, and expected results for tests.
Procedure to check the 120VAC electrical supply to the controller.
Procedure to measure thermistor resistance with power off.
Procedure to test motor resistance, door switch, and idle switch.
Procedure to test moisture sensor readings and voltage output.
Procedure to test door switch resistance in open and closed states.
Procedure to test heater switch and safety thermostats in electric dryers.
Procedure to test gas valve voltage and resistance.
Steps for converting between Natural Gas and Propane Gas settings.
Procedure for removing the dryer's top plate.
Steps to remove the control panel assembly and its components.
Procedure for removing the dryer's cabinet cover.
Steps to disassemble the front tub drum assembly.
Instructions for drum assembly and loosening the drive belt.
Procedure for replacing the lamp inside the dryer drum.
Instructions for changing or modifying the dryer exhaust duct.
Procedure for removing the dryer's filter assembly.
Steps to disassemble and remove the blower housing.
Procedure for removing the dryer's back cover.
Procedure for removing the dryer's air duct.
Steps to remove and replace the dryer rollers.
Exploded view of the control panel and associated plates.
Exploded view of the dryer's cabinet and door assembly.
Exploded view of the drum and motor assembly for electric dryers.
Exploded view of the drum and motor assembly for gas dryers.
