LG DLEX4000 Ultra Large Front Load Electric Dryer-Inlet Hose1
Connect all water supply
hoses tightly by hand and then tighten another 2/3 turn with pliers.
WITH WASHER: When connecting the dryer to the same faucet as a washer.
a. Shut off the cold water tap and remove the washer hose.
b. Connect the short hose to the Y-connector using one of the rubber seals.
c. Connect the other end of the short hose to the cold water faucet.
d. Connect the long dryer hose to one side of the Y-connector and connect the washer hose to the other side.
WITHOUT WASHER: If the dryer does not share the cold water tap with a washer.
a. Connect the straight end of the long hose to the cold water faucet.
NOTE
• Before connecting the water line to the dryer, flush several gallons of water into a drain or bucket. This will help
prevent foreign particles such as sand and scale from clogging the dryer inlet valve.
• Do not overtighten. Damage to the coupling may result.
3. Connect the hose to the dryer. Connect the water supply hose to the dryer inlet valve tightly by hand and then
tighten another 2/3 turn with pliers.
Make sure that there are no kinks in the hoses and that they are not crushed.
LG DLEX4000 Ultra Large Front Load Electric Dryer-2
4. Turn on the cold water faucet.
5. Check for leaks at the Y-connector (if used) and in all hoses.
To Next Page
Loading...
