Pull out the exhaust duct. Option
1: Side Venting
2. Press the tabs on the knockout and carefully remove the knockout for the desired vent opening (right-side
venting is not available on
gas models). Press the adapter duct onto the blower housing and secure it to the base of the dryer as shown.
LG DLEX4000 Ultra Large Front Load Electric Dryer-Installing the Side Vent Kit2
Preassemble a 4-inch (10.2 cm) elbow to the next 4-inch (10.2 cm) duct section, and secure all joints with duct tape.
Be sure that the male end of the elbow faces AWAY from the dryer. Insert the elbow/duct assembly through the side
opening and press it onto the adapter duct. Secure it in place with duct tape. Be sure that the male end of the duct
protrudes 1.5 inches (3.8 cm) to connect the remaining ductwork. Attach the cover plate to the back of the dryer with
the included screw.
To Next Page
Loading...
