LG DLG3171 Series - Steam Functions (Steam Models)

41OPERATION
ENGLISH
Steam Functions (Steam
Models)
Filling the Steam Feeder
Before using a Steam Cycle, the steam feeder must
be lled with water up to the lter screen. If not, an
error message will be displayed. Make sure that the
steam feeder is lled with water and the drawer is
fully closed. Turn the dryer off and then restart the
Steam Cycle.
1
Pull out the drawer.
2
Lift out the steam feeder.
3
Fill the steam feeder just to the lter screen.
Filter screen
4
Place the steam feeder in the drawer; then push
in the drawer until it clicks into place.
WARNING
To reduce the risk of serious injury or death,
follow basic precautions including the
following:
• Do not ll the steam feeder with liquids such
as gasoline, dry-cleaning solvents, or other
ammable or explosive substances.
• Do not drink water from the steam feeder.
NOTE
• An error message may be displayed even after
you ll the steam feeder with water up to the lter
screen. Fill the feeder again with water up to the
lter screen.
• Only use tap water. Do not ll the steam feeder with
foreign substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam
feeder is empty.
• Do not use distilled water; the water level sensor in
the steam generator will not work.
• Use care when placing a full Steam Feeder in the
drawer. The water may overow.
• Wipe up any spilled water around the Steam Feeder
and the drawer before starting the dryer.
• Do not ll the steam feeder with hot water (over
86°F/30°C).