To Next Page

To Previous Page

If you see a red LED on the wireless subwoofer or on the front of the wireless receiver, it means that the sound bar is not connected to

the speakers. If this is the case, connect them in the following order.

A Press the Power

button on the sound bar to turn it off.

B Press the Pairing (PAIRING) button on the back of the disconnected wireless subwoofer or wireless receiver. Check if each LED blinks green.

- If you still see a red LED on the wireless subwoofer, press and hold the button on the back of the subwoofer again.

C Press the Power

button on the sound bar to turn it on.

D When the connection is established, you will see a green LED light on the wireless subwoofer or on the front of the wireless receiver light up

green.

Keep the sound bar, the subwoofer and wireless receiver away from the device (ex. wireless router, microwave oven, etc.) over 1 m to prevent

wireless interference.

y Some speakers may not make sound depend on the input source. Select BASS BLAST sound mode to listen through all speakers.

y Design and specifications are subject to change without notice.

y Google Play is a trademark of Google LLC.

SC9S.DDEULLK_SIMPLE_MFL71970421.indd 4 2022-12-07  1:22:08

Questions and Answers:

Need help?

Do you have a question about the LG DSC9S and is the answer not in the manual?

LG DSC9S Specifications

General