48
EN
Error Messages
Symptoms Reason Solution
Water supply is not adequate
in area.
• Check another tap in the
house.
Water supply taps are not
completely open.
• Fully open tap.
Water supply hose(s) are
kinked.
• Straighten hose(s).
The lter of the supply
hose(s) are clogged.
• Check the lter of the supply
hose.
If water leakage occurred in
the aqua stop supply hose,
indicator
will become red.
May vary depending on the
model.
• Use the aqua stop supply
hose.
Load is too small.
• Add 1 or 2 similar items to
help balance the load.
Load is out of balance.
• Add 1 or 2 similar items to
help balance the load.
The appliance has an
imbalance detection and
correction system. If
individual heavy articles
are loaded (e.g. bath mat,
bath robe, etc.) this system
may stop spinning or even
interrupt the spin cycle
altogether.
• Rearrange load to allow
proper spinning.
If the laundry is still too wet
at the end of the cycle, add
smaller articles of laundry to
balance the load and repeat
the spin cycle.
• Rearrange load to allow
proper spinning.
Drain hose is kinked or
clogged.
• Clean and straighten the drain
hose.
The drain lter is clogged. • Clean the drain lter.
To Next Page
Loading...
Need help?
General
