38
EN
Symptoms Reason Solution
Washing machine
will not operate.
Control panel has powered off
due to inactivity.
• This is normal. Press the Power button to
turn the washing machine on.
Washing machine is
unplugged.
• Make sure cord is plugged securely into a
working outlet.
Water supply is turned off. • Turn the cold water tap fully on.
Controls are not set properly.
• Make sure the cycle was set correctly,
close the door and press the Start/Pause
button.
Door or drawer is open.
• Close the door and drawer make sure
that nothing is caught under the door
preventing it from closing completely.
Circuit breaker/fuse is
tripped/blown.
• Check house circuit breakers/fuses.
Replace fuses or reset breaker. The
washing machine should be on a
dedicated branch circuit. The washing
machine will resume the cycle where it
stopped once power is restored.
Control needs to be reset.
• Press the Power button, then re-select
the desired programme and press the
Start/Pause button.
Start/Pause was not pressed
after a cycle was set.
• Press the Start/Pause button with
control panel of the front-loading washing
machine or remote control after closing
the drawer.
• When using the control panel of the
pedestal washing machine, press the
Start/Pause button and close the drawer
within 5 seconds.
Extremely low water pressure.
• Check another tap in the house to make
sure that household water pressure is
adequate.
Washing machine is too cold.
• If the washing machine has been exposed
to temperatures below freezing for an
extended period of time, allow it to warm
up before pressing the Power button.
To Next Page
Loading...
