33
EN
Care in Cold Climates
• When frozen, the product does not operate
normally. Make sure to install the product
where it will not freeze during winter.
• Make sure to check the following.
How to Keep the Product from
Freezing
• After washing, remove water remaining inside
the pump completely with the opening hose
plug used for removal of residual water. When
the water is removed completely, close the
hose plug used for removal of residual water
and cover cap.
Drain plugDrain plug
Cover capCover cap
• Hang down drain hose to pull out water inside
the hose completely.
Drain hoseDrain hose
CAUTION
• When the drain hose is installed in a curved
shape, the inner hose may freeze.
• After closing the tap, disconnect the cold
supply hose from the tap, and remove water
while keeping the hose facing downwards.
Supply hoseSupply hose
Check for Freezing
• If water does not drain when opening the hose
plug used for removal of residual water, check
the drainage unit.
Drain plugDrain plug
Cover capCover cap
• Turn the power on, choose a washing
programme, and press the Start/Pause
button.
Drain hoseDrain hose
Detergent drawerDetergent drawer
• When ' ' is shown in display window while
the product is in operation, check water supply
unit and drainage unit (Some models do not
have an alarm function that indicates
freezing).
NOTE
• Check that water is coming into the detergent
drawer while rinsing, and water is draining
through the drain hose while spinning.