- 12 -
14)
Set Brightness and Contrast to Max position.
15)
Set SUB-CONTRAST 127(7F) (decimal) position.
16)
Set B-DRIVE to 85(55) at DRIVE of the alignment
program.
17-1)
Adjust R-DRIVE and G-DRIVE command to white
balance x=0.283
±
0.003 and y=0.298
±
0.003 on the
White Balance Meter with PC arrow keys.
17-2)
Display color 15,0 window pattern (70x70mm) at mode 4.
18)
Adjust SUB-CONTRAST command to 50
±
2FL .
19)
After push the “ENTER” key.
20)
Display color 15,0 full white patten at Mode 4..
21)
COLOR ADJ. → LUMINANCE → ABL command.
22)
Adjust ABL to 32
±
1FL of the luminance.
23)
After push the “ENTER” key, and “COMMAND →
PRESET EXIT → Y(Yes)” command.
24)
Exit from the program.
5. Input EDID Data.
1) Display color 15,0 cross hatch pattern at Mode 4.
2) EEPROM → Write EDID command and confirm
“EDID Write OK!!” message of monitor.
3) Exit from the alignment program.
4) Power switch OFF/ON for EDID data save.
6. Adjustment for Focus.
1) Set the Brightness and Contrast to max position.
2) Display H character in full screen at Mode 4.
3) Adjust two Focus control on the FBT that focus
should be the best condition.
To Next Page
Loading...
Need help?
General
