18
INSTALLATION
2
Firmly push the water tube onto the water inlet
valve and tighten up the collar nut.
Connecting to the Water Tap
This feature is only available on some models.
1
Push the water tube into the hole of the tap
connector supplied in the accessories. The pipe
should be held firmly whilst the connector is
pushed onto the pipe.
2
Ensure that the rubber washer is fitted to the
inside of the tap connector before screwing it
onto the tap.
• A separate connector or adaptor may need
to be purchased if your tap fitting does not
match the thread size of the connector
provided.
Checking the Water Connection
1
Turn on the water supply and switch on the
appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
2
Press and hold the
Water Filter
button for
three seconds. The new water filter has been
activated.
3
Place a cup under the water dispenser to verify
that water is flowing through the appliance.
4
Check the connecting tube and joints for leaks
once again.
Levelling and Door
Alignment
Levelling the Appliance
The appliance has two front levelling legs. Adjust
the legs to alter the tilt from front-to-back or side-
to side. If the appliance seems unsteady, or the
doors do not close easily, adjust the appliance’s tilt
using the instructions below:
1
Turn the levelling leg to the left to raise that
side of the appliance or to the right to lower it.
It may take several turns of the levelling leg to
adjust the tilt of the appliance.
• A flare nut wrench works best, but an open-end
wrench will suffice. Do not over-tighten.
2
Open both doors and check to make sure that
they close easily. If the doors do not close
easily, tilt the appliance slightly more to the
rear by turning both leveling legs to the left. It
To Next Page
Loading...
Need help?
General
