16
INSTALLATION
• This water line installation is not covered by the
appliance warranty.
Connecting Water to the
Appliance
1
Unscrew the metal threaded collar nut at the
back of the appliance and place it over one end
of the water tube.
2
Firmly push the water tube onto the water inlet
valve and tighten up the collar nut.
Connecting to the Water Tap
This feature is only available on some models.
1
Push the water tube into the hole of the tap
connector supplied in the accessories. The pipe
should be held firmly whilst the connector is
pushed onto the pipe.
2
Ensure that the rubber washer is fitted to the
inside of the tap connector before screwing it
onto the tap.
• A separate connector or adaptor may need
to be purchased if your tap fitting does not
match the thread size of the connector
provided.
Only For Germany
• Connect your appliance only to a water tap with
a safety device (according to EN 1717) to avoid
drinking water pollution through water
backflow.
• To be sure, please ask your installer. In case
water tap is without backflow prevention valve
(according to EN 1717), you have to use an extra
backflow prevention valve compliant with
German drinking water ordinance between
water tap and water inlet hose.
Checking the Water Connection
1
Turn on the water supply and switch on the
appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
2
Press and hold the
Water Filter
button for
three seconds. The new water filter has been
activated.
3
Place a cup under the water dispenser to verify
that water is flowing through the appliance.
4
Check the connecting tube and joints for leaks
once again.
global_main.book.book Page 16 Tuesday, June 29, 2021 5:42 PM
To Next Page
Loading...
