LGE Internal Use Only
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 130 -
12. AUTO CALIBRATION
12.5 AGC
This procedure is for Rx calibration.
In this procedure, We can get RSSI correction value. Set band EGSM and press Start button the
result window will show correction values per every power level and gain code and the same
measure is performed per every frequency.
12.6 APC
This procedure is for Tx calibration.
In this procedure you can get proper scale factor value and measured power level.
12.7 ADC
This procedure is for battery calibration.
You can get main Battery Config Table and temperature Config Table will be reset.
To Next Page
Loading...
