10
BEFORE USE
ENGLISH
Inserting batteries
Insert AAA (1.5 V) batteries before using the
remote control.
1 Remove the battery cover.
2 Insert the new batteries and make sure
that the + and - terminals of the batteries
are installed correctly.
3 Reattach the battery cover.
Installing the remote control holder
To protect the remote control, install the hold-
er where there is no direct sunlight.
1 Choose a safe and easily-accessible place.
2 Fix the holder by fastening the 2 screws
firmly with a screwdriver.
3 Slide the remote control into the holder.
Point the remote control towards the signal
receiver at the bottom of the air conditioner
to operate it.
Setting the current time
1 Press p and hold it for longer than 3 sec-
onds.
- The AM/PM icon flickers at the bottom of
the display screen.
2 Press
E
or
F
to select the minutes.
3 Press p to finish.
°C/°F Conversion
The unit switches between °C to °F or
from °F to °C if The Temperature Display
Button ( ) is pressed for 5 seconds.
NOTE
!
If the display screen of the remote control
starts to fade, replace the batteries.
NOTE
!
• The remote control may operate other
electronic devices if pointed towards
them. Make sure to point the remote
control towards the signal receiver of
the air conditioner.
• For proper operation, use a soft cloth to
clean the signal transmitter and receiv-
er.
• Jet mode in Heating does not work
when equipped with a wired remote
controller.
• ON/OFF reserve mode does not work
when equipped with a wired remote
controller.
Operating method
To Next Page
Loading...
