ADVANCED FUNCTIONS
15
ENGLISH
Auto Changeover operation
This mode changes the operation mode auto-
matically to maintain the set temperature
at ±4 °F (2 °C).
1 Press | to turn on the power.
2 Press f repeatedly until C is displayed
on the display screen.
3 Press
G
or
H
to set the desired tem-
perature between 64 °F (18 °C) and 86 °F
(30 °C).
4 Press g repeatedly to select the fan
speed.
LH (Low Heating)
This function operates the heating system to
maintain a minimum indoor temperature and
prevent indoor objects from freezing in a
situation where there is no permanent resi-
dent, such as a vacation home.
1 Turn the air conditioner on.
2 Press f repeatedly to select the Heating
Mode.
3 Press for 3 seconds.
- is displayed on the display screen.
Single zone wall mounted models
NOTE
!
This function may not be supported,
depending on the model.
NOTE
!
• is activated in Heating Mode only.
• When function is set, the indoor unit
maintains operation mode (Fan speed is
high and the vane is set maximum
angle) and room temperature between
48 °F~55 °F (9 °C~13 °C), and display
desired temperature display on the
indoor unit display as . (LH = Low
heating)
• During operation, when you press
buttons such as
g , _ , f or for 3
seconds, and then return to
[heating / previous temperature / pre-
vious fan speed].
• If
M
is pressed during operation,
end function and immediately execute
Power Heating. (only for power heating
model)
• In case an error occurred, operation can
be interrupted for the protection of the
product.
To Next Page
Loading...
