15
USING YOUR REFRIGERATOR
ENSURING PROPER AIR CIRCULATION
In order to ensure proper temperatures, air must flow
between the refrigerator and freezer sections. As shown
in the illustration below, air enters at top of freezer and
circulates down. From bottom of freezer, air is forced up
to top of refrigerator. Air enters refrigerator through top
vent, then circulates and exists at bottom, where it returns
to freezer.
MULTI-FLOW
Multi-Flow means powerful and effective cooling
operation. This is especially noticeable when new food
is placed in the refrigerator compartment.
If water or foreign substances enter the cool air vent
while cleaning, efficiency will be lowered. In addition, if the
gasket is damaged, efficiency may be lowered because
of escaping cool air.
Do not block any of cool air vents with food packages. If
the vents are blocked, airflow will be interrupted and
temperature and moisture problems may occur.
IMPORTANT: Because air circulates between both sections,
Any odors formed in one section will transfer to the other.
You must thoroughly clean both sections to eliminate odors.
To prevent odor transfer and drying out of food, wrap or
foods tightly. (See the Food Storage Guide section for
CONTROL PANEL FEATURES
Press the button for the desired function to review and
select other settings. For complete details on button
functions see pages 16-17.
DOOR ALARM
With this feature you´ll listen a alarm when the freezer or
refrigerator door is not closed within 1 minute after it is
opened. These tones repeat every 30 seconds.
The alarm is cancelled when the freezer or the refrigerator
is closed correctly.
details).
• LED DISPLAY
The LED display shows the
temperature settings, dispenser
options, and the water filter, door
alarm, and locking status
messages.
Display Off Mode: To activate energy save mode press and
hold ICE PLUS and FREEZER key over 5 seconds until the
lights turn off. If the Display is touched or any door opens
the lights will turn on and after 20 seconds of inactivity the
lights will turn off automatically. To exit Display OFF Mode
press and hold ICE PLUS and FREEZER key over 5
seconds until the lights tilt. Display Energy Save Mode does
not affect the temperature control settings of the unit.
• LIGHT/FILTER
The LIGHT/FILTER button
controls the lamp in the d ispenser.
The FILTER/FILET button resets
the water filter replacement
indicator when the water filter has
been replaced.
• ICE TYPE
The ICE TYPE is used to select
cube ice or crushed ice.
• FREEZER
Press the FREEZER button to
adjust the temperature in the
freezer compartment.
• REFRIGERATOR
Press the REFRIGERATOR
button to adjust the temperature in
the refrigerator compartment.
NOTE: When pressed
simultaneously with the FREEZER
button for more than five seconds,
the temperature display will
change from Fahrenheit to Celsius
or vice versa.
• ICE PLUS
Press this button to turn on the
ICE PLUS. Feature, which
increases ice making capabilities
up to about 20 percent.
• ALARM/LOCK
Press this button to control the
door-open alarm.
Press this button to lock or unlock
all the other function buttons on
the control panel, including
operation of the dispenser.
To Next Page
Loading...
