- 29 -
8-1-5 Ice Plus selection
Please select this function for quick freezing.
• Function is repeat Ice Plus Icon whenever pressing Ice Plus button.
• Ice Plus function automatically turns off after a fixed time passes.
8-1-7 DISPENSER LIGHT
- Whenever pressed the LIGHT button, DISPLAY is changed as belows.
Normal status: When dispenser is operated, DISPENSER LIGHT is ON.
ON status: DISPENSER LIGHT is on continuously.
8-1-6 Dispenser use selection
You can select water or ice.
*
Select water, crushed ice, or ice cubes by cycling through the
selections when pressing the DISPENSER button,
*
Hold your cup in the dispenser for a few seconds after
dispensing ice or water to allow the last pieces of ice or drops of
water to fall into the cup.
*
When after initially establishing the water comes out, the water
tank inside fills and until at the time of quality the hour is caught.
8-1-8 CONTROL OF FREEZER FAN MOTOR
1. Freezer fan motor has high and standard speeds.
2. High speed is used at power-up, for Ice Plus, and when refrigerator is overloaded.
Standard speeds is used for general purposes.
3. To improve cooling speed, the RPM of the freezer fan motor change from normal speed to high.
4. High speed (2700RPM): Initial power on or load corresponding operation, Ice Plus
Normal speed (2400RPM): General working conditions.
5. Fan motor stops when refrigerator or freezer door opens.
8-1-9 Cooling Fan Motor
1. The cooling fan is switched ON and OFF in conjunction with the compressor.
2. The cooling fan runs at a single speed.
3. The failure sensing method is the same as in the fan motor of the freezing fan motor(refer to failure diagnosis function
table for failure display).
8-1-10 Icing Fan
1. The Icing Fan is controlled by the the sensor on the top of the ice room.
2. The failure sensing method is the same as in the fan motor of the freezer
(refer to failure diagnosis function table for failure display)
Pressing
Switch
To Next Page
Loading...
