48 TROUBLESHOOTING
NotdispensingDoorsarenotclosed Icewillnotdispenseifanyoftherefrigerator
ice. completely, doorsareleftopen.
Infrequentuseofthedispenser.
Icemakerisnot
makingice.
Thedeliverychuteisdogged
withfrostoricefragments.
Infrequentuseoftheicedispenserwillcause
thecubestosticktogetherovertime,which
willpreventthemfromproperlydispensing.
Checktheicebinforicecubesclumping!sticking
together.Iftheyare,breakuptheicecubesto
allowforproperoperation.
Eliminatethefrostoricefragmentsbyremoving
theicebinandclearingthechutewithaplastic
utensil.Dispensingcubedicecanalsohelp
preventfrostoricefragmentbuildup.
Thedispenserdisplayislocked.PressandholdtheLockbuttonforthreeseconds
tounlockthecontrolpanelanddispenser.
Icebinisempty.
Refrigerator was recently
installed or icemaker recently
connected.
Icemaker not turned on.
The ice detecting sensor is
obstructed.
The refrigerator is not connected
to a water supply or the supply
shutoff valve is not turned on.
Icemaker shutoff (arm or
sensor) obstructed.
Reverse osmosis water filtration
system is connected to your
cold water supply.
It may take up to 24 hours for each compartment
to reach the desired temperature and for the
icemaker to begin making ice. Make sure that the
shutoff
(arm/sensor) is not obstructed.
Once the ice supply in the bin has been
completely exhausted, it my take up to 90
minutes before additional ice is available, and
approximately 24 hours to completely refill the
bin.
It may take up to 24 hours for each compartment
to reach the desired temperature and for the
icemaker to begin making ice.
Locate the icemaker ON/OFF switch and confirm
that it is in the ON (1)position.
Foreign substances or frost on the ice-detecting
sensor can interrupt ice production. Make sure
that the sensor area is clean at all times for proper
operation.
Connect refrigerator to the water supply and turn
the water shutoff valve fully open.
If your icemaker is equipped with an ice shutoff
arm, make sure that the arm moves freely. If
your icemaker is equipped with the electronic ice
shutoff sensor, make sure that there is a clear
path between the two sensors.
Reverse osmosis filtration systems can reduce
the water pressure below the minimum amount
and result in icemaker issues.
(Refer to the Water Pressure section.)
To Next Page
Loading...
