- 11 -
3-13 ICE CORNER DOOR REPLACEMENT
1) Loosen the front screw as shown in the picture.
2) Remove the Cover Home Bar as shown in the picture.
3-12 WATER BUTTON ASSMEBLY
1) Remove 3 screws holding the Funnel and Button Lever
2) Remove the Funnel and Button Lever
3) Push the hook
Button Lever
hinge
3-9 DISPENSER
1) Pull out the drain
2) Holding the inner side of
the dispenser pull
forward to remove.
3-10 DISPLAY PCB
As shown below, remove the Display PCB fixing screws.
3-11 ICE BUTTON ASSEMBLY
1) Remove the 1 screw holding the lever.
2) Remove the spring from the hook.
3) Push and pull on the tab to remove.
CAUTION: When replacing the dispenser cover make
sure the lead wire does NOT come off and the water line
is not pinched by the dispenser.
Button Lever
Display PCB
3) Remove the lead wire.
3) Lift up the hinge with one hand.
4) Pull out the Ice Corner Door with the other hand.
Cover Home
Bar
To Next Page
Loading...
