39
Installing the micro-USIM card
Before you start exploring your new phone, you may choose to insert the micro-USIM
card.
The eject button is a small round aperture on the bottom of the tray door. To install a
new micro-USIM card:
1 Insert the micro-USIM ejection tool that comes with the phone (or a thin pin) into
the eject button aperture, and push gently but firmly until the tray pops out.
2 Remove the tray and place the micro-USIM card inside it, with the contacts out and
the angled corner to the right. There is only one possible way to fit the card snugly
into the tray.
3 Carefully reposition the tray in the slot and push it gently back into the phone.
NOTE: Make sure the gold contact area on the card is facing downwards.
Eject button aperture
To Next Page
Loading...
