10. CALIBRATION
10.6 Overview of RF Calibration
10.6.1 Supported entry of RF Calibration
As using QTR8200, E730 adopts some of calibrations in those of QTR8200. This is also supporting Quad band
WCDMA and Quad band GSM. Table 10.6.1 and Table 10.6.2 describes the information listed for RF
calibration items used by E730.
Calibration WCDMA 2100 WCDMA 1900 WCDMA 900 WCDMA 850 description
Tx Sweep
Calibration
Tx output power
measurements
Tx Hdet Calibration HDET ADC measurements
vs Tx power
Tx Comp vs Freq
Calibration
16-channel Tx output
measurements in a certain
PDM
Tx Secondary
Comp vs Freq
Calibration
๑ ๑ ๑ ๑
Irregular Tx power
measurements in a certain
PDM
Tx Lim vs Freq
Calibration
HDET ADC measurements
in the Target Power
Rx DVGA Gain
Offset Calibration
Rx DVGA gain
measurements
Rx DVGA Gain
Offset vs Freq
Calibration
16-channel RX DVGA gain
measurements
Rx LNA Range
Offset Calibration
LNA gain offset
measurements
Rx LNA Range
Offset vs Freq
Calibration
16-channel LNA gain
offset measurements
Table 10.6.1. The calibration list for WCDMA
Calibration GSM900 GSM850 GSM1800 GSM1900 description
VCO Calibration
๑ ๑ ๑
Lowest frequency error- VCO
measurement
Thermistor Calibration
Thermistor max/min ADC
measurement regardless of band
Tx External Polar Calibration Tx output power measurements
Polar path delay Calibration
๑ ๑ ๑ ๑
PM and AM signal path delay
Carrier Suppression
Calibration
๑ ๑ ๑ ๑
carrier power measurement
Rx Gain Range Calibration 8 or 16 channel Rx Gain
measurements
For more information, refer to “80-VP447-13_RF_NV_ITEMS.pdf”.
Table 10.6.2 The calibration list for GSM