PARTS, TOOLS, MATERIALS
You will need the following tools and materials for the installation:
Carton or other heavy material for covering the counter top.
Clear Tape
(for taping the templates to the wall)
Saber Saw
_ (for cutting vent holes for roof
or wall venting)
Phillips Screwdriver
Stud Finder
Pencil
Flat Blade Screwdriver
Measuring Tape
Keyhole Saw (for the power cord hole)
Electric Drill
3/8" and 3/4" wood drill bits c_"
1/2" and 3/16" _
drill bits
Plumb Line
Duct Tape
Caulking Gun
Small Side Cutters or Tin Snips
Gloves
• If you have brick or masonry walls, you will need special hardware and tools.
• The ductwork you need for the installation is not included. All wall and roof caps must have a back-draft damper.
(Shown on page 5).
-6-
To Next Page
Loading...
Need help?
General
