LG LP090CED LP120CED - Suggested Tool Requirements; Preparation of Sleeve; Preparation of the Front Grille

—21—
3.2.1 PREPARATION OF SLEEVE
ASSEMBLE THE WALL SLEEVE
• Raise the sleeve side panels to upright position as shown on
the right.
• Place sleeve upper on top of side panels.
• Fasten the four screws as shown on the right.
• Assemble the drain kit.
• Fasten this assembly to the each side of the wall sleeve as
shown on the right.
• Assemble the outdoor grille and fasten the 4 screws as
shown on the right.
3.2.2 PREPARATION OF THE FRONT GRILLE
Carefully remove shipping tape from the front grille.
SCREWDRIVER (FLAT and PHILLIPS), RULER, KNIFE, HAMMER, PENCIL, LEVEL
I
N
D
O
O
R
I
N
D
O
O
R
INDOOR
IN
D
O
O
R
I
N
D
O
O
R
14
12
11
Shipping Tape
I
N
D
O
O
R
3.2 SUGGESTED TOOL REQUIREMENTS
SLEEVE HARDWARE
NUMBER NAME OF PARTS Q’TY
LOVER SLEEVE 1
UPPER SLEEVE 1
SCREW 4
OUTDOOR GRILLE 1
DRAIN KIT 1