ENGLISH ESPAÑOLFRANÇAIS
13
2. Remove bolt J and hinge-C K and take off
refrigerator door L.
Move cap M to the side not used.
Move door bracket P and screw Q to the
side you wish and reinstall.
3. Move hinge-U pin N and top cover cap O.
Assemble the refrigerator door L.
Assemble hinge-C K and bolt J.
Assemble freezer door .
Assemble the hinge-L E and bolt D.
Assemble base cover A and screw B.
After Completing the job
■ Make sure that the four corners of the door
gasket are not folded. It is recommended to
apply a small amount of silicon grease on
them.
■ Adjust the leveling screw on the bottom to
the highest level so that the front side of the
refrigerator is higher than the rear side.
■ If you need assistance after switching the
direction of the door opening as shown
above, call a service center.
To Next Page
Loading...
Need help?
General
