14 OPERATION
Auto Operation (Artificial
Intelligence)
Cooling Only Model
This mode automatically sets the fan speed and
temperature depending on the room temperature.
1
Turn the appliance on.
2
Press MODE button repeatedly to select the Auto
Operation.
•
is displayed on the display screen.
3
Press or button to select the desired
operation code if the temperature is higher or
lower than the desired temperature.
Code Description
2 Cold
1 A little cold
0 Maintain room temperature
-1 A little hot
-2 Hot
NOTE
• In this mode, you cannot adjust the fan speed, but
you can set the air deflector to rotate automatically.
Auto Changeover Mode
Cooling & Heating Model
This mode changes the mode automatically to
maintain the set temperature at ±2 °C
1
Turn the appliance on.
2
Press MODE button repeatedly to select the Auto
Changeover Mode.
•
is displayed on the display screen.
3
Press or button to set the desired
temperature.
4
Press FAN SPEED button to adjust the fan
speed.
Dehumidification Mode
This mode removes excess moisture from a highly
humid environment or during the rainy season,
in order to prevent mildew from setting in. This
mode adjusts the room temperature and the fan
speed automatically to maintain the optimal level of
humidity.
1
Turn the appliance on.
2
Press MODE button repeatedly to select the
Dehumidification Mode.
•
is displayed on the display screen.
NOTE
• In this mode you cannot adjust the room
temperature, it is adjusted automatically.
• The room temperature is not displayed on the
display screen.
• In the dehumidification mode, compressor and
indoor fan may not operate when the room
temperature is below 24 °C
To Next Page
Loading...
