5-19
NOTE : • MAKE SURE THE WIRE LEADS CORRECT POSITION.
• WHEN REMOVING THE WIRE LEADS FROM THE PARTS, BE SURE TO GRASP THE CONNECTOR,
AND NOT THE WIRES.
• WHEN REMOVING THE MAGNETRON, BE SURE TO INSTALL THE MAGNETRON GASKET IN THE
CORRECT POSITION AND GOOD CONDITION.
CONDITION
Grill indicator lights
but oven does not go into
cook cycle when START key
is touched.
Temperature in the oven
cavity is lower or higher then
preset.
Defective relay 3 of P.C.B.
Test procedure relay 3 of
P.C.B.
CAUSE
TEST PROCEDURE OR
CORRECTION
Open or loose wire
connection to the above
components.
Check and repair wiring.
Open or loose wire
connection to P.C.B.
Check and repair wiring.
Test procedure relay 3 of
P.C.B.
Test procedure grill heater.
Defective relay 3 of P.C.B.
Defective grill heater
element.
(TROUBLE 5) Oven does not operating Grill cooking
To Next Page
Loading...
Need help?
General
