Enter a user-defined end frequency range.
Set Satellite Setting
You can add/delete/set the satellite you want.
This function only works when the programme mode is satellite.
Satellite
Select your desired Satellite.
LNB Frequency
Select one value from 9750/10600, 9750/10750, 9750, 10600, 10750, 11300, 5150,
MDU1, MDU2, MDU3, MDU4, MDU5. If you select 9750/10600, 9750/10750(MHz),
22kHz Tone is disabled. If you cannot find the LNB frequency value from the list,
select User and manually enter the frequency.
Some models may not be supported.
Transponder
Select the transponder you want to tune.
22kHz Tone
When using 22kHz Tone switch, select 22kHz or 0 Hz. If you use 22kHz Tone,
Unicable and Motor Type are disabled.
LNB Power
To enable the power supply for the LNB, select On. If you select Off, Motor Type is
disabled.
DiSEqC
When using DiSEqC, select one option from A~D/ToneA~B. If you use DiSEqC,
Unicable and Motor Type are disabled.
Unicable
Select On to use Unicable and set the Unicable in the Unicable Settings menu.
To Next Page
Loading...
