To Next Page

To Previous Page

ENGLISH

[Status Mailing]

[Ez Setting] [Status Mailing]

This feature configures the system so that the status of the device is assessed and then notified to the administrator

by e-mail.

• [On/Off]: Turns [Status Mailing] on or off.

• [Mailing Option], [Scheduling]: Sets the email sending interval.

• [User E-mail Address]: Set the user email address of the sender.

• [Sending Server (SMTP)]: Set the address of the SMTP server.

• [ID]: Enter the account ID of the sender.

• [Password]: Enter the password for the sender’s account.

• [Receiver E-mail Address]: Set the email address of the recipient.

• [Send message]: Immediately assess the status of the device and deliver the information to the specified email

address.

• [Reset]: Reset to initial settings.

NOTE

• If the status regarding any of the following items changes or becomes abnormal, a status message can be sent.

- 1. LAN Status, WiFi Status: An email is sent when the network’s connection status is changed. The maximum

number of network status changes that can be saved is limited to 50. The saved value is reset once the power

turns off.

- 2. No Signal Check: Checks whether there is a signal. If there are no signals for more than 10 seconds, an email is

sent.

- 3. Schedule Play Status: An email is sent if content cannot be played between the scheduled start time and end

time in either Content Management Schedule status or SuperSign Content status. However, this does not apply

when terminated using the remote control.

- 4. Fail Over Status: An email is sent if input switching occurred due to an error. (Excludes input switching initiated

by the user (RC, RS232C, SuperSign))

• Only SMTP ports 25, 465, and 587 are supported.

• The occurrence of internal input switches, excluding external input switches (RC, RS232C, SuperSign), are considered

as Fail Over Status.

• One email containing the “Failover status: Failover” message is sent when switching to Fail Over Status, and the

following status emails sent regularly or upon status changes contain the message “Failover status: None”.

LG ProBeam BU60RG User Manual

Questions and Answers: