14
INSTALLATION
8
Cut the non-adhesive foam strip to the
proper length and insert it between the
upper window sash and the lower window
sash.
Foam Strip
(Non-adhesive)
9
Attach the window locking bracket with a
type C screw.
Window Locking Bracket
10
Cut the adhesive-backed heatproof foam
to match the size of the curtain panels.
Remove the backing from the heatproof
foam and attach it to the curtain panels.
Heatproof Foam
NOTE
●Heatproof foam improves the cooling
capability of the air conditioner.
11
Fold out the vent control lever located to
the left of the control panel, as shown.
NOTE
●See the 'Electrical Data' section for information
on attaching the power cord to an electrical
outlet.
12
Connect the wire harness from the front
grille assembly to the air conditioner.
13
Attach the front grille assembly to the
cabinet by inserting the grille tabs into the
slots on the front of the cabinet. Push the
grille in until it snaps into place.
NOTE
● Carefully guide the vent control lever
through the grille as you push the grille in.
14
Take out the filter and secure the front
grille assembly with 2 type A screws
through the both sides of the front grille.
(There 2 type A screws are packaged by
bag.)
To Next Page
Loading...
