Operating Your Dryer
63
O
perating Your Dryer
5. Close the door.
Before you close the door, make sure fab-
rics are well placed inside and that foreign
objects, especially flammable ones, are not
caught around door.
6. Select the drying cycle you want.
You can choose a cycle by turning the cycle
selector knob until the required cycle is indicated.
If you press Start/Pause button without choosing a
cycle, the dryer will proceed with the Cupboard
cycle. [Please refer to Cycle Selection table
(page 61) for the detailed information.
7. Press the start button.
You will hear drum rotating.
8. After the cycle has finished, open the
door and remove the laundry.
(Operation time varies depending on your cycle
selection or options.)
9. Clean the filter and empty water
container.
The filter should be cleaned after each load.
10. Turn off the dryer.
Press the ‘‘Power’’ button.
Select the
desired
cycle.
Take out
the laundry.
Clean the
filter.
(Replace
the filter
if it is
damaged.)
- Be careful not to trap laundry between the
loading door and rubber seal.
CAUTION
- Take care if using a vacuum cleaner to clean
the filter, as it is easily damaged and torn.
If there is a residue build up on the filter,
scrub the filter with a brush to remove.
- If you want to open the door while the dryer
is operating, please press the Start/Pause
button first, wait until the drum completely
stops and then open the door.
CAUTION
Be careful! The drum inside could still be hot.
CAUTION
It must not be used for purposes other than
those for which it was designed.
CAUTION
Note
The final part of a tumble dryer cycle occurs
without heat (cool down cycle) to ensure that
the items are left at a temperature that will not
damage them.
Never stop a tumble dryer before the end of
the drying cycle unless all items are quickly
removed and spread out so that the heat is
dissipated.
WARNING
To Next Page
Loading...
Need help?
General
