32
PROGRAMMING MODE
10. Value of coin 2 (Set up for top off price and e-suds coin pulse)
Entering set up
mode.
You will see LqC1
Button Display
Press the High Temp. button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Display previous coin 2 value.
Press Med Temp.(+) or Low Temp.(-) button to select value of
coin 2 (The value can be set fronm 0 to 9,90 in 0.1 increments.)
Press the Start button.
The machine sets up the value of coin 2, then advances to the
next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/o toggle switch.
• Card type - Pull the service card.
• Stack type - 1. Control panel open.
2. Turn on/o toggle switch.
• OPL/Coin Type - Press “High Temp.” twice.
• Coin type : Value of coin 2 is same function as setting for the e-Suds coin pulse.
• Card type : Value of coin 2 is same function as the top off price.
(As changing the value of coin 2, you can change the top off price and e-Suds coin pulse.)
NOTE
MFL62512875_150414.indd 32 2015.4.14 9:43:57 AM
To Next Page
Loading...
Need help?
General
