System Setting 27
System Setting
3
7. Select [Next] and press ENTER (
b
).
8. You can listen to TV sound through this unit’s
speaker automatically when TV is turned on. TV
and this unit should be connected with optical
cable.
Press
W
to move and press
A/D
to select [On]
or [Off ]. Select [Next] and press ENTER (
b
).
9. Check all the settings that you have set in the
previous steps.
Press ENTER (
b
) while [Finish] is highlighted
to finish the initial setup settings. If there is any
settings to be changed, use
W/S/A/D
to
select
1
and press ENTER (
b
).
To Next Page
Loading...
