ENGLISH
Specification
Power requirements
y Refer to the main label.
Power consumption
y Refer to the main label.
Soundbar dimensions (W x H x D): Approx. 1250.0 mm x
63.0 mm x 135.0 mm (49.2 inch x 2.5 inch x 5.3 inch)
Wireless rear speakers dimensions (W x H x D): Approx.
100.0 mm x 176.5 mm x 120.0 mm (3.9 inch x 6.9 inch x
4.7 inch)
Bus Power Supply (USB): 5 V 0 500 mA
Amplifier (Total RMS Output power): 670 W RMS
Open Source Software Notice Information
To obtain the source code that is contained in this product,
under GPL, LGPL, MPL, and other open source licenses that
have the obligation to disclose source code, and to access all
referred license terms, copyright notices and other relevant
documents, please visit https://opensource.lge.com.
LG Electronics will also provide open source code to you
on CD-ROM for a charge covering the cost of performing
such distribution (such as the cost of media, shipping, and
handling) upon email request to opensource@lge.com.
This offer is valid to anyone in receipt of this information
for a period of three years after our last shipment of this
product.
FCC Compliance Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
y Reorient or relocate the receiving antenna.
y Increase the separation between the equipment and the
receiver.
y Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
y Consult the dealer or an experienced radio/TV technician
for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference and (2) this
device must accept any interference received, including
interference that may cause undesired operation. Any
changes or modifications in construction of this device which
are not expressly approved by the party responsible for
compliance could void the user’s authority to operate the
equipment.
FCC RF Radiation Exposure Statement: This equipment
complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-
located or operating in conjunction with any other antenna
or transmitter.
This equipment should be installed and operated with
minimum distance 20 cm (7.8 inches) between the antenna
and your body. Users must follow the specific operating
instructions for satisfying RF exposure compliance.
FCC Radio Frequency Interference Requirements:
High power radars are allocated as primary users of the
5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar
stations can cause interference with and/or damage this
device. This device cannot be co-located with any other
transmitter.
Supplier’s Declaration of Conformity
Trade Name LG
Responsible Party LG Electronics USA, Inc.
Address 111 Sylvan Avenue, North Building
Englewood Cliffs, New Jersey 07632
Email lg.environmental@lge.com
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO
NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This lightning flash with arrowhead symbol
within an equilateral triangle is intended to
alert the user to the presence of
uninsulated dangerous voltage within the
product’s enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the product.
WARNING:
y TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO
NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
y Do not install this equipment in a confined space such as
a book case or similar unit.
CAUTION:
y Do not use high voltage products around this product.
(ex. Electrical swatter) This product may malfunction due
to electrical shock.
y No naked flame sources, such as lighted candles, should
be placed on the apparatus.
y Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
Slots and openings in the cabinet are provided for
ventilation and to ensure reliable operation of the product
and to protect it from over heating. The openings should
never be blocked by placing the product on a bed, sofa,
rug or other similar surface. This product shall not
be placed in a built-in installation such as a bookcase
or rack unless proper ventilation is provided or the
manufacturer’s instruction has been adhered to.
S90TR.DUSALLK_SIMPLE_MFL72100313.indd 5 2024-03-08 10:42:01
To Next Page
Loading...
Need help?
General
