LG T1603TEFT - Page 19

Close the lid Finish Caution & Note
START
PAUSE
• The pulsator rotates for
8 seconds to detect the
laundry load.
• Then the WATER LEVEL
and the amount of
Detergent to be used
will be shown and
water will be supplied.
• Water will be
supplied for 2
minutes after the start
of the wash to
supplement the
water the laundry
has absorbed.
• When the wash
program ends, the
buzzer will ring for
10 seconds before
the Power goes off
automatically.
• If water is already in the tub, or
putting wet laundry into the tub
before starting will increase the
WATER LEVEL.
• With lightweight bulky loads,
WATER LEVEL can be set low.
• Changes to Water Temperature
(HOT/COLD) and wash level are
possible during operation.
(refer to page 14)
3
5
6
7
6
7
6
4
4
7
6
4
• When setting the WATER LEVEL
manually, do not set to Medium to
prevent damage to laundry.
• Washing with HOT water may
damage the laundry (Water is set to
cold automatically). Ensure that the
load is under 2kg.
• In order to avoid damage to laundry,
the spin cycle may appear slow.
This also avoids wrinkles and
clothing may still contain some
water. This is normal.
• When static pressure of water is
more than 2kg/cm
2
, the QUICK
WASH course will be within
19min.
7
6
4
19