LG W081CM - Page 26

Possible Trouble 6 Remote controller does not operate.
Is the voltage of Battery
about over 2.3V?
* Exchange the battery.
s the voltage No.10
of CN-DISP2 on Main PCB
Ass'y DC 5V?
Is
the
connection
of
NO
*
Connect
connector
to
CN-DISP2 all right?
CN-DISP2 exactly.
e Exchange Receiver Ass y. |
Possible Trouble 7 It displays abnormally on display PCB Ass'y.
Is the ICO1G all right?
• Exchange IC01G.
Is the connection of
CN-DISP2 all right?
Does the Q12G,
Q13G, Q14G operate normally
on main PCB Ass y?
e Exchange Q12G,
BESO
• Exchange the display
PCB Ass'y.