12 OPERATION
Settings (Hour Mode, Convection
Auto Conversion, Oven
Temperature, Display Language,
Preheat Alarm Light, Beeper
Volume, Fahrenheit or Celsius)
Press the Clock button repeatedly to toggle
through and change oven settings.
The Settings allows you to:
• set the hour mode on the clock (12 or 24 hours)
• enable/disable convection auto conversion
• adjust the oven temperature
• select display language
• activate/deactivate the preheating alarm light
• set the beeper volume
• switch the temperature scale between
Fahrenheit and Celsius
Setting the Hour Mode
The controller is set to use a 12-hour clock. To
reset the clock to 24-hour mode, follow the steps
below.
1 Press and hold Clock for 3 seconds to enter
the settings mode.
CLO appears in the display.
2 Press 1 to select a 12-hour clock, or 2 to select
a 24-hour clock.
3 Press START to accept the change.
Setting Convection Auto Conversion
When Conv. Bake and Conv. Roast are selected,
Convection Auto Conversion automatically
converts the standard recipe temperature entered
to a convection temperature by subtracting 25 ℉ /
14 ℃. This auto converted temperature shows on
the display. For example, select Conv. Bake, enter
350 ℉, and 325 ℉ shows on the display after
preheat.
Convection Auto Conversion is enabled by default.
To change the setting, follow these instructions.
1 Press and hold Clock for 3 seconds to enter
the settings mode. Press Clock repeatedly
until
Avto appears in the display.
2 Press 1 to enable or 2 to disable auto
conversion.
3 Press START to accept the change.
Adjusting the Oven Temperature
Your new oven may cook differently from the one
it replaced. Use your new oven for a few weeks to
become more familiar with it before changing the
temperature settings. If after familiarizing yourself
with the new oven, you still think that it is too hot
or too cold, you can adjust the oven thermostat
yourself.
• To begin, either raise or lower the thermostat 15
℉ (8 ℃). Try the oven with the new setting. If the
oven still needs adjustment, raise or lower the
thermostat again, using the first adjustment as a
gauge. For example, if the adjustment was too
much, raise or lower the thermostat 10 ℉ (5 ℃).
If the adjustment was not enough, raise or lower
the thermostat 20 ℉ (12 ℃). Proceed in this way
until the oven is adjusted to your satisfaction.
1 Press and hold Clock for 3 seconds to enter
the settings mode. Press Clock repeatedly
until
U-AJ or L-AJ appears in the display.
2 Use the number buttons to enter the number
of degrees you want to adjust the oven
temperature.
3 Adjust the temperature either up or down by
pressing Clock repeatedly to toggle between
plus (+) or minus (-).
4 Press START to accept the change.
• This adjustment does not affect the broiling or
Self Clean temperatures. The adjustment is
retained in memory after a power failure. The
oven temperature can be increased (+) or
decreased (-) as much as 35 ℉ or 19 ℃.
• Once the temperature is increased or decreased,
the display shows the adjusted temperature
until it is changed.
Selecting the Display Language
The oven control is set to display in English but can
be changed to display in Spanish or French.
1 Press and hold Clock for 3 seconds to enter
the settings mode. Press Clock repeatedly
until
LNG appears in the display.
To Next Page
Loading...
Need help?
General
