LG WF-T1480TD - Page 34

3) Disassembly of Lid Assembly, Top
Cover, Tub Cover, Pulsator & Inner Tub
Remove Q-spring & two hinge pins then
disassemble the lid assembly
Remove two top cover xing screws in the rear
then disassemble the top cover.
Remove tub cover xing screws then disassemble
the tub cover.
Remove the pulsator xing screw then
disassemble the pulsator.
Remove the hub xing nut by a special tool.
Disassemble the inner tub.
4) Disassembly of Back Cover, Drain Pump,
Clutch(Transmission) & Motor
Remove back cover xing screws then disassemble
the back cover.
Disconnect the leads and the drain hose-p from the
drain pump.
Remove the pump xing screws then
disassemble the drain pump.
Fall down the washer for clutch & motor removal.
Remove the belt.
Disassemble the clutch.
Remove two motor xing screws then
disassemble the motor.
5) Replacement of Damper asm
Separate top cover from washing machine.
As in the g, lift snubber bar and take it out of out
case with out tub.
Damper assembly shall not be disassembled.
Replace damper as assembly.
For assembly, keep the following.(Location & color)
Location P/No. PIVOT(Color)
A051 NATURAL
A052 BLUE
Tub cover
Inner tub
Hub xing nut
Leads
Drain hose-p
Pump xing screw
34